Tectite 3/4 in. Push-to-Connect x 3/4 in. Female Pipe Thread x 18 in. Braided Stainless Steel Water Heater Connector
Product Overview
The 3/4 in. x 18 in. Tectite by Apollo Water Heater Connector was designed for the fast and simple installation of hot and cold water lines to water heaters. After applying pipe thread tape to the MNPT nipples on your water heater, thread the FNPT end of the Water Heater connector onto the tank and tighten with pliers. Then simply push the Tectite by Apollo Push-To-Connect end onto Copper, PEX, or CPVC pipes and your water heater is connected. The stainless steel braided connectors are available in different lengths from 12 in. - 24 in. (without Ball Valve) and are also available in Corrugated Stainless Steel.
- Constructed of lead free dezincification resistant (DZR) brass and braided stainless steel for superior reliability and strength
- Push-to-connect joints require no heat, solder, solvents or tools
- Push-to-connect design allows for a simple and fast installation of water heaters to any combination of copper, PEX, CPVC or PE-RT pipe
- Fittings can be rotated after being installed for ease of use in tight spaces
- Ideal for potable water and hydronic heating applications
- Meets UPC, IPC, and cUPC standard requirements and listed by IAPMO and listed to ASSE 1061/NSF 59
- Demount clip allows for valve removal (included)
- Corrosion resistant for greater longevity
- Maximum working pressure of 200 psi
- Maximum temperature of 250 degree F
Proposition 65 Information
WARNING: This product contains chemicals known to the state of California to cause cancer and birth defects or other reproductive harm. Further information available at www.p65warnings.ca.gov.
Documentation
Owner's ManualSpecifications
Warranty
5 Years: Must be installed per published installation instructions.